I replaced my old heater with a "Marey Eco 110"
It powers up, and water runs through it. If I turn on the hot water at the faucet, it comes out, but it's not hot. I don't know what to do. The display shows numbers like 52:12, -053, & 120.. which would be minimum and max temps, but in fahrenheit and celcius.. I can raise and lower them with the arrow buttons but it doesn't matter.
No hot water. No manual/instructions. The website's pdf isn't helping. No specific youtube videos. Nothing.
Apparently if water goes through these things too fast it won't heat, so I tightened a valve to slow it down and it didn't do anything. The wiring is the same wire from the old heater, which was also 220v. 12 gauge wire on it's own breaker.
All I can figure is I need to screw with the unit itself? With nothing online to go by I guess that's why I'm here. I called them but got nobody, gonna email them too.
any ideas?
THANK YOU :/ :)
It powers up, and water runs through it. If I turn on the hot water at the faucet, it comes out, but it's not hot. I don't know what to do. The display shows numbers like 52:12, -053, & 120.. which would be minimum and max temps, but in fahrenheit and celcius.. I can raise and lower them with the arrow buttons but it doesn't matter.
No hot water. No manual/instructions. The website's pdf isn't helping. No specific youtube videos. Nothing.
Apparently if water goes through these things too fast it won't heat, so I tightened a valve to slow it down and it didn't do anything. The wiring is the same wire from the old heater, which was also 220v. 12 gauge wire on it's own breaker.
All I can figure is I need to screw with the unit itself? With nothing online to go by I guess that's why I'm here. I called them but got nobody, gonna email them too.
any ideas?
THANK YOU :/ :)
Walang komento:
Mag-post ng isang Komento