Good Afternoon,
I'm attempting to put in recessed lighting into my living room. Before installing the lights this was the set up:
Two switchs, one on either side of the room. Two wall outlets controlled by then switchs.
From what I can tell, power comes into the first switch then breaks off to the second switch.
I installed a dimmer at the switch at the end of the line. Before putting in the lights, all switches and outlets worked correctly.
I then went into the attic. I found the line going from one switch to the other. I spliced in the lights. Coming into the lights, black was hot.
After the install, I turned on the power and got nothing. I went to test one of the spare outlets with a sawsall to see if I have power. As soon as I turned on the saw, my lights worked. My lights will only work when the saw is on.
I can't seem to figure out what wiring is wrong to only get lights when the saw completesnthe circut.
Anyone have any suggestions? Thank you.
I'm attempting to put in recessed lighting into my living room. Before installing the lights this was the set up:
Two switchs, one on either side of the room. Two wall outlets controlled by then switchs.
From what I can tell, power comes into the first switch then breaks off to the second switch.
I installed a dimmer at the switch at the end of the line. Before putting in the lights, all switches and outlets worked correctly.
I then went into the attic. I found the line going from one switch to the other. I spliced in the lights. Coming into the lights, black was hot.
After the install, I turned on the power and got nothing. I went to test one of the spare outlets with a sawsall to see if I have power. As soon as I turned on the saw, my lights worked. My lights will only work when the saw is on.
I can't seem to figure out what wiring is wrong to only get lights when the saw completesnthe circut.
Anyone have any suggestions? Thank you.
Walang komento:
Mag-post ng isang Komento