The alarm was fine until I tried to add another zone. I hooked up the door sensor from my shop to the system but it all went downhill when I tried to incorporate the sensor in the available zone 5. I apparently turned things off and misconfigured the zones and now my zone 1 for my house is not recognized.
I had it doing everything from arming itself just by opening the doors in the house on zone 1, until now I have zone 1 jacked up and it will not arm itself when I enter the code to arm it. Now it just counts down indefinitely but never really stops counting. Zone 1 still shows "open" when I open the door, but I cannot arm it. I DID remove the new shop door switch from the zone 5 but zone 1 is still erratic and I cannot arm it. HELP.
I had it doing everything from arming itself just by opening the doors in the house on zone 1, until now I have zone 1 jacked up and it will not arm itself when I enter the code to arm it. Now it just counts down indefinitely but never really stops counting. Zone 1 still shows "open" when I open the door, but I cannot arm it. I DID remove the new shop door switch from the zone 5 but zone 1 is still erratic and I cannot arm it. HELP.
Walang komento:
Mag-post ng isang Komento