Hello, I have an old Kenmore washer (model 110.4221090 which is Sears Canada). It was purchased used and I've never seen it running, it was in the back of a pickup truck for a 4 hour trip.
It will fill with water and once filled it completely stops and does not make any noise at all. I can leave it turned on to spin cycle and unplug it from the wall then back in and it doesn't even make a peep.
I checked the lid switch for continuity and it is good, I also bypassed the lid switch and had the same issue. I ran through this motor test: https://repairave.com/washerrepair_wpl_motor.asp (2 speed, identical to the one in the pictures) and all of the resistances were OK.
I can only assume it is a bad timer? When I put it on a normal cycle and it stops filling the timer does not advance or make any noise. If I manually cycle the timer on it's own there are certain clicks where I can hear it working again, then it will reach a stage where it clicks and stops working, then if I manually move it forward it will kick in again.
Could it be something else? Any help is appreciated.
It will fill with water and once filled it completely stops and does not make any noise at all. I can leave it turned on to spin cycle and unplug it from the wall then back in and it doesn't even make a peep.
I checked the lid switch for continuity and it is good, I also bypassed the lid switch and had the same issue. I ran through this motor test: https://repairave.com/washerrepair_wpl_motor.asp (2 speed, identical to the one in the pictures) and all of the resistances were OK.
I can only assume it is a bad timer? When I put it on a normal cycle and it stops filling the timer does not advance or make any noise. If I manually cycle the timer on it's own there are certain clicks where I can hear it working again, then it will reach a stage where it clicks and stops working, then if I manually move it forward it will kick in again.
Could it be something else? Any help is appreciated.
Walang komento:
Mag-post ng isang Komento